Shaping with wire:
With this technique can create bonsai by changing the direction of the trunk and branches. Pointing to growing branches can be bent horizontally or swipe down to impress older, mature.
Bending Zinc evergreen trees at some point also be (but with coniferous types such as the best time is late fall to early spring).
Should deciduous trees bending in late spring (before the trees sprout) or late fall (before hibernation). In fact, we should rely on tree branches to choose soft, flexible, pliable and not branched.
Zinc wrapping:
+ Wrap the trunk: Cut a length of wire with an arm or 3 times to wrap the body. Maybe winding body circling a 45o angle, which is the most efficient way of wrapping. Wrapping: Plug one end into the ground zinc, wrapped around the tree first, and then wrapped up the trunk. If you want to wrap again, you should wrap the rope close to the front and do not necessarily overlap wrap.
+ Wrap branches: Begin wrapping from the bottom. Also winding interspersed along the length of the branch until finished whole trees (back wrap on the shoots very meticulous). Or we wrapped at once both the main branch and side branch before next wrap. Using finer wire for the thickness of thin branches. Typically, wrap the two branches at once with the same wire wrap, wrapped around the body to create a world based. In areas where single branch, the branch should be wrapped linked to other, forcing the line clicked by several tuck it under the first round.
+ How often are removed by winding? This depends thickness of stems, plants, quality and age of the tree. Should regularly check the wound to ensure wire windings to ensure not worked into the shell when the plants grow. Remove the wrap wire around three to six months to deciduous trees, six to twelve months with evergreen trees. Be careful when selecting wire size suitable for the size and the growth of plants. Winding up the size change according to the thickness of the arm relative to smaller wire size, wire size 1/6 to 1/3 respectively of the branches or trunk diameter wrap selected. To remove the wound, the better off you should cut the wire into small sections, in order to reduce the risk and damage to trees.
Into the pot and change the land:
When potted soil nutrients were depleted, the phenomenon Bonsai: Trees no longer fresh, the phenomenon of distress, the less fresh leaves and yellow tinged sickness started, the spike as high take-up can not be, many rootlets bulging of the soil, surface soil layer thinning out pots. These symptoms indicate that it’s time to replace soil for plants.
According to the weather should be to sink our country in the spring or before the rainy season when the trees start to sprout, which is emerging buds and cool weather.
Use a blunt knife roll slowly into the pot close to the land until the potting soil and the pot is split or the previous one we irrigate the land really flabby, so just tilt the pot is taken up by plants.
Proceed cut large roots and rootlets were too old and just leaving the young roots. Should use pliers to cut off the roots, unfortunately, need for fresh cut, not broken to pieces. After processing roots must be neatly finished.
This is also a good time to do pruning the branches, branches grow improperly, or modify them